Commands Listed in Alphabetical Order
Arguments
CH1-CH4 is the c
hannel to use as the SPI MISO source.
D0-D15 is the digital channel to use as the SPI MISO source.
BUS:B<x>:SP
I:DATA{:OUT|:MOSI}:POLARity
Sets or returns the SPI MOSI polarity for bus <x>, where x is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Bus
Syntax
BUS:B<x>:SPI:DATA{:OUT|:M OSI}:POLARity {LOW|HIGH}
BUS:B<x>:SPI:DATA{:OUT|:M OSI}:POLARity?
Arguments
LOW specifies the active low polarity.
HIGH specifies the active high polarity.
BUS:B<x>:SPI:DATA{:OUT|:MOSI}:SOUrce
Sets or returns the SPI MOSI source for bus <x, where x is the bus number>.
Conditions
This command requires a DPO2EMBD application module.
Group
Bus
Syntax
BUS:B<x>:SPI:DATA{:OUT|:M OSI}:SOUrce {CH1|CH2|CH3| CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D 8|D9|D10|D11|D12|D13|D14|D15}
BUS:B<x>:SPI:DATA{:OUT|:M OSI}:SOUrce?
Arguments
CH1-CH4 is the channel to use as the SPI MISO source.
D0-D15 is the digital channel to use as the SPI MISO source.
BUS:B<x>:SPI:DATA:SIZe
Sets or returns the number of bits per word for the specified SPI bus.
2-88 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
