Commands Listed in Alphabetical Order
Arguments
CH1–CH4 is the a
nalog c hannel to use as the data source.
D0–D15 is the digital channel to use as the data source.
BUS:B<x>:DISplay:FORMAt
Sets or returns the display format for the numerical information in the bus
waveform <x>, where x is the bus number.
Conditions
This command requires a DPO2AUTO, DPO2EMBD, or D PO2COMP application
module.
Group
Bus
Syntax
BUS:B<x>:DISplay:FORMAt {BINary|HEXade cimal|ASCII|MIXe d}
BUS:B<x>:DISplay:FORMAt?
Related Commands
BUS:B<x>:TYPE
Arguments
BINary specifies a binary data display.
HEXadecimal specifies a hexadecima l data display.
ASCII specifies an ASCII format for RS232 only.
MIXed specifies a mixed format for LIN only.
BUS:B<x>:I2C:ADDRess:RWINClude
Sets and returns whether the read/write bit is included in the address.
Conditions
This command requires a DPO2EMBD application module.
Group
Bus
Syntax
BUS:B<x>:I2C:ADDRess:RWINC lude {<NR1>|OFF|ON}
BUS:B<x>:I2C:ADDRess:RWINC lude?
Arguments
<NR1> = 0 does not include the read/write bit in the address; any other value
includes the read/write bit in the address.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-75
To Next Page
Loading...
Need help?
General
