Tektronix KEITHLEY DMM6500 User Manual

Section
2: Performance verification DMM6500 6½-Digit Multimeter with Scanning
Calibration and Adjustment Manual
2-46 DMM6500-905-01 Rev. E June 2021
Verify dc voltage zero values using the 4-wire short
To verify dc voltage zero values:
1. Leave the short connected as described in Verify resistance zero values using a 4-wire short
(on
page 2-45).
2. Press the FUNCTION key.
3. Select the DC Voltage function.
4. Press the HOME key.
5. Set the range to 1000 V.
DC voltage verification is done in descending range order, starting with the 1000 V range and
finishing on the 100 mV range.
6. Verify that the 1000 V range zero is within specification. See the table below.
7. Verify that the 100 V to 100 mV range zero is within specification.
Verify dc voltage zero values
Range Lower limit Upper limit
1000
-6000
6000
100
-600
600
10
-50
50
1
-6
6
100 mV
-3.5
3.5
Rear-panel verification
The following topics describe verification procedures that are done with connections attached to the
terminals on the DMM6500 rear panel.

Tektronix KEITHLEY DMM6500 Specifications

General

Brand	Tektronix
Model	KEITHLEY DMM6500
Category	Multimeter
Language	English