Commands Listed in Alphabetical Order
Examples
MEASUREMENT:I
MMED:DELAY:EDGE1 RISE
specifies that the "from" waveform
rising edge be used for the immediate delay measurement.
MEASUREMENT:
IMMED:DELAY:EDGE1?
returns either RISE or FALL.
MEASUrement:IMMed:SOUrce<x>
For SOURce1: This command specifies the source for all single channel
measurements. For delay or phase measurements, this command specifies the
waveform to measure "from". This is equivalent to setting the "From:" waveform
in the "Measure Delay" side menu or the "Measure Phase" side menu. SOUrce is
equivale
nt to SOURCE1.
For SOUrce2: This command specifies the waveform to measure "to" when taking
adelaym
easurement or phase measurement. This is equivalent to setting the "To:"
waveform in the "Measure Delay" side menu or the "Measure Phase" side menu.
NOTE. If you do not specify a numerical suffix,thesourceisassumedtobe
SOUrce1.
Group
Measurement
Syntax
MEASUrement:IMMed:SOUrce<x>
{CH1|CH2|CH3|CH4|MATH|D0|D1|D2|D3|D4|D 5|D6|D7|D8|D9|D10
|D11|D12|D13|D14|D15|HIStogram|RF_AMPl itude|RF_FREQuency|RF_PHASe}
MEASUrement:IMMed:SOUrce<x>?
Arguments
CH1–CH4 is the analog channel to use as the source waveform.
MATH is the math waveform.
D0 — D15 is the digital waveform to use as the source waveform.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
HIStogram indicates the histogram as the object to be measured. HIStogram only
applies to SOUrce1; it is not available for SOUrce2.
RF_AMPlitude|RF_FREQuency|RF_PHASe are the RF time domain traces.
(MDO4000/B/C only.)
MEASUrement:IMMed:TYPe
This command specifies the immediate measurement type.
2-424 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
