Commands Listed in Alphabetical Order
Related Comma
nds
WFMInpre:WFMT
YPe
Arguments
TIMe specifies to treat the information to be transferred as integer values.
FREQuency specifies to treat the information to be transferred as floating point
values.
Examples
WFMInpre:DOMain FREQuency specifies to treat the information to be
transferred from a PC to a reference location as floating point values.
WFMInpre:DOMain? might return TIME, indicating that the information is being
treated as integer values (time domain).
WFMInpre:ENCdg
This command specifies the type of encoding of the incoming waveform data
to be sent to the oscilloscope using the
CURVe command. Supported types are
BINary and ASCii.
(See page 2-95, Waveform Transfer Command Group.)
Group
Waveform Transfer
Syntax
WFMInpre:ENCdg {ASCii|BINary}
WFMInpre:ENCdg?
Related Commands
WFMOutpre:ENCdg
Arguments
ASCii specifies that the incoming data is in ASCII format.
BINary specifies that the incoming data is in a binary format whose further
interpretation requires knowledge of BYT_NR, BIT_NR, BN_FMT, and
BYT_OR.
Examples
WFMINPRE:ENCDG ASC sets the format of incoming waveform data to ASCII
format.
WFMINPRE:ENCDG ? might return :WFMINP RE:ENCDG BIN indicating that the
incoming waveform data is in binary format.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-949
To Next Page
Loading...
Need help?
General
