Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Syntax
WFMInpre:PT_F
mt {ENV|Y}
WFMInpre:PT_Fmt?
Related Commands
WFMOutpre:PT_Fmt?
Arguments
ENV specifies that the waveform is to be transmitted in envelope mode as
minimum and maximum point pairs. Only
Y values are explicitly transmitted.
Absolute coordinates are given by:
Xn = XZEro + XINcr (n - PT_Off)
Ynmax = YZEro + YMUlt (ynmax - YOFf)
Ynmin = YZEro + YMUlt (ynmin - YOFf)
Y specifies a normal waveform where one ASCII or binary data point is
transmitted for each point in the waveform record. Only
Y values are explicitly
transmitted. Absolute coordinates are given by:
Xn = XZEro + XINcr (n - PT_Off)
Yn = YZEro + YMUlt (yn - YOFf)
Examples
WFMINPRE:PT_FMT ENV sets the incoming waveform data point format to
enveloped.
WFMINPRE:PT_FMT? might return :WFMINPRE:PT_FMT ENV indicating that the
waveform is transmitted as minimum and maximum point pairs.
WFMInpre:PT_Off
The set form of this command is ignored. The query form always returns a 0.
(This command is listed for compatibility with other Tektronix oscillos
copes.)
(See page 2-95, Waveform Transfer Command Group.)
Group
Waveform Transfer
Syntax
WFMInpre:PT_Off <NR1>
WFMInpre:PT_Off?
Arguments
Arguments are ignored.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-951

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English