Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre:YOFf?
Related Commands
DATa:SOUrce,
WFMOutpre:BYT_Nr
Examples
WFMOUTPRE:YOFF? might return :WFMOUTPRE:YOFF -50.0000E+0 indicating
that the position indicator for the waveform was 50 digitizing levels (2 divisions)
below cen
ter screen (for 8-bit waveform data).
WFMOutpre:YUNit? (Query Only)
This query returns the units of data points in the outgoing waveform record
transferred using the
CURVe? query. This can be any of several string values,
depending upon the vertical units of the source waveform (specified by the
DATa:SOUrce command). Typically, this is “V” for volts. If the waveform
speci
fied by DATa:SOUrce is not turned on, nothing is returned and an error
event is generated.
(See p
age 2-95, Waveform Transfer Command Group.)
(See page D-1, Wa veform Transfer (WFMOutpre and CURVe Query) Examples.)
Group
Waveform Transfer
Syntax
WFMOutpre:YUNit?
Related Commands
DATa:SOUrce
Examples
WFMOUTPRE:YUNIT? might return :WFMOUTPRE:YUNIT "dB" indicating that
the vertical units for the waveform are measured in decibels.
WFMOutpre:YZEro? (Query Only)
This query returns the vertical offset of the source waveform. You can
determine the units using the WFMOutpre:YUNit? query. See the description of
WFMInpre:YZEro to see how this offset is used to convert waveform sample
values to volts. If the waveform specified by DATa:SOUrce is not turned on,
nothing is returned and an error event is generated.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-973

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English