Commands Listed in Alphabetical Order
Arguments
ON enables the d
isplay of date and time.
OFF disables the display of date and time.
<NR1> = 0 disables the display of date and time; any other value enables the
display of date and time.
Examples
DISPLAY:CLOCK ON enables display of date and time.
DISPLAY:CLOCK? might return :DISPLAY:CLOCK 1 indicating that the display
of date and time is currently enabled.
DISplay:CONFIGure:READOut
Configures or queries readout backgrounds. NORMal is used for standard opaque,
and TRANSParent for transparent. This setting applies to all on-screen readouts
on the waveform area, such as channel, measurements, cursor, math, or bus, etc.
Group
Display
Syntax
DISplay:CONFIGure:READOut{NORMal ! TRANSParent}
DISplay:CONFIGure:READOut?
Arguments
NORMalsets all readout backgrounds to the standard opaque background.
TRANSParent sets all readout backgrounds to transparent mode.
DISplay:DIGital:ACTIVity
Sets or returns the state of the digital channel monitor display. When enabled, the
digital channel monitor is displayed when one or more of D0-D15 are turned on.
The data that is summarized in that display can be obtained by querying CURVe
with the DATa:SOUrce set to
DIGital and one or more digital channels D0-D15
turned on.
For more information, refer to the description of DIGital in the section entitled
“Transferring a Waveform From an Oscilloscope to a Computer”. (See page 2-96,
Transferring a Waveform fro m an Oscilloscope to a Computer.)
Conditions
Available only for MSO/MDO4000/B models and for MDO3000 and MDO400C
models with option MDO3MSO or MDO4MSO installed.
Group
Display
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-289
To Next Page
Loading...
Need help?
General
