Commands Listed in Alphabetical Order
Examples
ETHER:LXI:LAN
:STAT?
might return FAULT, indicating the network is not
visible, or the network settings are incorrect.
ETHERnet:NAME
This command specifies the network name assigned to the oscilloscope.
Group
Ethernet
Syntax
ETHERnet:NAME <QString>
ETHERnet:NAME?
Arguments
<QString> is the network name assigned to the oscilloscope, enclosed in quotes.
Examples
ETHERNET:NAME “labscope1” sets the oscilloscope's network name.
ETHERnet:NETWORKCONFig
This command specifies the Ethernet network configuration setting. The default
is automatic.
Group
Miscellaneous
Syntax
ETHERnet:NETWORKCONFig {AUTOmatic|MANual}
ETHERnet:NETWORKCONFig?
Related Commands
ETHERnet:NAME,
ETHERnet:IPADDress,
ETHERnet:SUBNETMask,
ETHERnet:GATEWay:IPADDress,
ETHERnet:DHCPbootp
Arguments
AUTOmatic specifies that the oscilloscope’s IP address, subnet mask and gateway
settings will be received from a DHCP server on the local network.
MANual specifies that the Ethernet settings will be configured
manually, using ETHERnet:IPADDress, ETHERnet:SUBNETMask,and
ETHERnet:GATEWay:IPADDress.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-313
To Next Page
Loading...
Need help?
General
