Commands Listed in Alphabetical Order
Syntax
MASK:TEMPLate
:SOUrce {C H1|CH2|CH3|CH4|REF1|REF2|REF 3|REF4}
MASK:TEMPLate:SOUrce?
Related Commands
MASK:TEMPLate:CREATEmask,
MASK:TEMPLate:TOLerance:HORizontal,
MASK:TEMPLate:TOLerance:VERTical,
SAVe:MASK
MASK:TEMPLate:TOLerance:HORizontal
This command specifies the horizontal limit (tolerance) for a template maskto
be used for limit testing. This indicates how far horizontally from the template
source to create the mask.
A series of examples showing how to use mask commands for typical tasks
is included in an appendix. (See page E-1, Mask/Limit Command Sequence
Examples.)
Conditions
This command requires a DPO4LMT application module for 4000 series models,
and an MDO3LMT application module for MDO3000 series models.
Group
Mask
Syntax
MASK:TEMPLate:TOLerance:HORizontal <NR3>
MASK:TEMPLate:TOLerance:HORizontal?
Related Commands
MASK:TEMPLate:CREATEmask,
MASK:TEMPLate:TOLerance:VERTical,
SAVe:MASK
Arguments
<NR3> is a floating point value that specifies the horizontal limit (tolerence) in
milli-divisions. Range: 0 to 500 mDiv, resolution: 1mDiv, default: 40mDiv.
This value cannot be negative.
Examples
If you create a limit mask after a default setup, then query:
:MASK:TEMPLate:TOLerance:HORizontal?
you get the response: 200.000E-3
Now send the commands:
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-383