Save and Recall I
nformation
Printing a Hard Copy
To print an image of what appears on the oscillo scope screen, do the following procedure.
Connect a Printer to Your Oscilloscope
When you connect the oscilloscope to a PictBridge compatible printer, the oscilloscope and printer c an be powered on or off.
1. Connect a U SB cable to the rear-panel USB
port.
2. Insert the other end of the cable into the
appropriate port on a PictBridge compatible
printer. Refer to the product documentation
for your printer to locate the port.
3. To test the connection, set up the
oscilloscope to print as described in the next
procedure.
NOTE. The oscilloscope recognizes the printer only w hen the printer is powered on.
If the oscillosco
pe asks you to connect to a printer and a printer is connected, you need to power on the printer.
SettingUpPrintParameters
To set up the oscilloscope to print hard copies:
1. Push Utility.
2. Push Utility Page.
Utility
Page
3. Turn multipurpose knob a and select Print
Setup.
Utility
Page
Print Setup
Ink Saver
On
PictBridge
Printer
Settings
120 MSO2000B and DPO2000B Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
