Field or control Description
Data Packet Type Sets the data packet type on which to trigger.
Available when Trigger On = Data Packet.
Data Bytes Sets the number of data bytes on which to trigger (one to two bytes). Tap the field and use the
A knob to change the value.
Available when Trigger On = Data Packet.
Byte Offset Sets the byte offset (Don't Care or the number of bytes). Tap the field and use the A knob to
change the value.
Available when Trigger On = Data Packet.
Data Sets the data packet pattern on which to trigger. The number of bits shown depends on the
Data Bytes setting. Use in conjunction with the Trigger When field to specify the exact trigger
condition.
Tap the Binary, Hex, or ASCII field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Data Packet and Trigger When = anything but Inside Range or
Outside Range.
Trigger When Sets the trigger when condition.
When set to Inside Range or Outside Range, fields are displayed to set a high and low
boundary pattern for the specified trigger type.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Token Packet or Data Packet.
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Menus and dialog boxes
376 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
