USB Flash Drive and Device Ports
USB Device Por
t
You can use a U SB cable to connect the oscilloscope to a PC. The USB Device
port is on the rear of the oscilloscope.
USB Device port
Installing the PC Communications Software on a PC
Before y
ou connect the oscilloscope to a PC with Tektronix OpenChoice
PC Communications Software, you must download that software from
www.tektronix.com/software and install it on your PC.
CAUTION. If you connect the oscilloscope to your PC before you install the
software, the PC will not recognize the oscilloscope. The PC w ill label the
oscilloscope as an Unknown Device and not communicate with the oscilloscope.
To av
oid this, install the software on your PC before you connect the oscilloscope
to your PC.
NOT
E. Be sure you have installed the latest version of PC Communications
software.
So
ftware for your oscilloscope is available through the Software finder on the
Tektronix web site.
To install the PC Communications software, follow these steps:
1. Run the OpenChoice Desktop software on the PC. The InstallShield w izard
appears on the screen.
2. Follow the on-screen directions.
3. Exit the InstallShield wizard.
TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual 65
To Next Page
Loading...
Need help?
General
