To Next Page

To Previous Page

Brief Procedures

4–14

TDS 500B, 600B and TDS 700A Service Manual

e. Save the settings:

H Press SETUP.

H Press the main-menu button Save Current Setup; then press the

side-menu button To File.

H Turn the general purpose knob to select the file to save. Choose

 (or ). With this choice, you will save a file

starting with , then containing 5-numbers, and a  extension.

For example, the first time you run this on a blank, formatted disk or

on the Example Programs Disk, the oscilloscope will assign the

name  to your file. If you ran the procedure again, the

oscilloscope would increment the name and call the file

.

H Press the side-menu button Save To Selected File.

2. Verify the file system works:

H Press the main-menu button Recall Factory Setup and the side-menu

button OK Confirm Factory Init to restore the 500 ms time base and

the five cycle waveform.

H Press the main-menu button Recall Saved Setup; then press the

side-menu button From File.

H Turn the general purpose knob to select the file to recall. For example, if

you followed the instructions above and used a blank disk, you had the

oscilloscope assign the name TEK00000.SET to your file.

H Press the side-menu button Recall From Selected File.

H Verify that Digitizing Oscilloscope retrieved the saved setup from the

disk. Do this by noticing the horizontal SCALE for the M (main) time

base is again 200 ms and the waveform shows only two cycles just as it

was when you saved the setup.

3. Remove the test hookup:

H Disconnect the probe from the channel input and the probe-compensa-

tion terminals.

H Remove the disk from the disk drive. Do this by pushing in the tab at the

bottom of the disk drive.

Tektronix TDS 700A Service Manual

Other manuals for Tektronix TDS 700A