Maintenance
6-- 26
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
You will need a torque-limiting Torx T-15 screwdriver and a flat-blade screw-
driver for this procedure.
Removal. To remove the front-panel module, refer to Figure 6--16 and follow
these steps:
1. Remove the power button and rear case using the procedures on pages 6--10.
2. Remove the entire internal assembly from the front case using the procedure
on page 6--17.
3. Disconnect the front-panel ribbon cable at J202 on the main board by pulling
straight up from the connector.
4. Remove the four screws attaching the front-panel module to the internal
assembly.
5. Pull the module away from the internal assembly.
Internal
assembly
Main
board
Front-panel
ribbon cable
Front-panel module
Figure 6--16: Removing the front-panel module
Front-Panel Module
To Next Page
Loading...
Need help?
General
