Maintenance
6-- 46
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
Repackaging Instructions
Use these procedures to repackage the oscilloscope for shipment or storage.
Use a corrugated cardboard shipping carton having a test strength of at least
125 kg (275 pounds), and with an inside dimension at least 15.25 cm (six inches)
greater than the oscilloscope dimensions. Make sure that the oscilloscope is
adequately padded with a cushioning material like foam, paper, or bubble wrap.
The oscilloscope should not move around inside of the carton when sealed.
If the oscilloscope is being shipped to a Tektronix Service Center, enclose the
following information:
H The owner address
H Name and phone number of a contact person
H Type and serial number of the oscilloscope
H Reason for returning
H A complete description of the service required
Seal the shipping carton with an industrial stapler or strapping tape.
Mark the address of the Tektronix Service Center and also your own return
address on the shipping carton in two prominent locations.
The oscilloscope should be stored in a clean, dry environment. The following
environmental characteristics apply for both shipping and storage (oscilloscope
not operating):
H Temperature range: --20 °Cto+60°C
H Altitude: To 15,000 m
See the chapter Specifications for a complete listing of the environmental
characteristics.
Packaging
Storage
To Next Page
Loading...
Need help?
General
