Tektronix TDS210 User Manual

Command Groups
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-23
Table 2- 15: Math commands (Cont.)
Header Description
MA TH:FFT:HORizontal:SCAle
(TDS200 with a TDS2MM module, TDS1000,
TDS2000, TDS1000B, TDS2000B, and
TPS2000 only)
Set or query the FFT hori-
zontal zoom factor
MATH:FFT:VERtical:POSition
(TDS200 with a TDS2MM module, TDS1000,
TDS2000, TDS1000B, TDS2000B, and
TPS2000 only)
Set or query the FFT vertical
display position
MATH:FFT:VERtical:SCAle
(TDS200 with a TDS2MM module, TDS1000,
TDS2000, TDS1000B, TDS2000B, and
TPS2000 only)
Set or query the FFT vertical
zoom factor
MA TH:VERtical? Return all math vertical
waveform parameters
MATH:VERtical:POSition
(TDS1000B, TDS2000B, and TPS2000 only)
Set or query the math wave-
form display position
MATH:VERtical:SCAle
(TDS1000B, TDS2000B, and TPS2000 only)
Set or query the math wave-
form display scale
Measurement Commands
Measurement commands control the automated measurement
system. The oscilloscope can display up to four (TDS200) or five
(TDS1000, TDS2000, TDS1000B, TDS2000B, a nd TPS2000)
automated measurements. In the commands, these measurement
readouts are named MEAS<x>, where <x> ca n be 1, 2, 3, or 4 (or 5
for TDS1000, TDS2000, TDS1000B, TDS2000B, and TPS2000).
The best method for taking mea surements over the computer
interface is to use the MEASUREMENT:IMMED commands and
queries. The immediate measurement has no front-panel equivalent,
and the oscilloscope never displays immediate measurements.

Tektronix TDS210 Specifications

General

Brand	Tektronix
Model	TDS210
Category	Test Equipment
Language	English