Tektronix TDS210 User Manual

Command Groups
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-33
Table 2- 22: Save and Recall commands
Header Description
*RCL Recall setting
RECAll:SETUp Recall saved oscilloscope setting
RECAll:WAVEform Recall saved waveform
*SAV Save oscilloscope setting
SAVe:IMAge
(TDS2MEM, TDS1000B,
TDS2000B, and TPS2000 only)
Save screen image to file
SAVe:IMAge:FILEFormat
(TDS2MEM, TDS1000B,
TDS2000B, and TPS2000 only)
Set screen image file format
SAVe:SETUp Save oscilloscope setting
SAVe:WAVEform Save waveform
Status and Error Commands
Status and error commands let you determine the status of the
oscilloscope and control events.
Several commands and queries are common to all devices on the
GPIB or USB bus. These commands a nd queries are defined by
IEEE Std. 488.2–1987 and Tek Standard Codes and Formats 1989,
and begin with an asterisk (*) character. Table 2--23 lists and
describes Status and Error commands.
Table 2- 23: Status and Error commands
Header Description
ALLEv? Return all events
BUSY? Return oscilloscope busy status
*CLS C lear status

Tektronix TDS210 Specifications

General

Brand	Tektronix
Model	TDS210
Category	Test Equipment
Language	English