TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
2-45
Command Descriptions
Commands either set or query oscilloscope values. Some commands
both set and query, some only set, and some only query.
Manual Conventions
This manual uses the following conventions:
H No query form exists for commands identified as “Set Only”
H A question mark (?) appended to the command and “Query
Only” indicates query-only commands
H Fully spells out headers, mnemonics, and arguments with the
minimal spelling shown in upper case; for exampl e, to use the
abbreviated form of the ACQuire:MODe command, just type
ACQ:MOD
H Syntax of some commands varies, depending on the model of
oscilloscope and extension module you use; differences are noted
H Command descriptions list specific oscilloscopes series (and
module) when commands are valid for only those products
NOTE. While Trigger View is active (when you push the TRIG VIEW
button on the front panel), the oscilloscope ignores the set form of
most commands. If you send a command at this ti me, the oscilloscope
generates execution error 221 (Settings conflict).
ACQuire? (Query Only)
Returns current acquisition settings.
Acquisition
Group
To Next Page
Loading...
Need help?
General
