Tornado BD 14/4 User Manual

GB GB
The brush motor does not work
1. Check the charge level of the
batteries that is visible when
activating first the main switch (1)
(see under “BATTERIES
RECHARGING”).
2. Verify that the brush motor
switch (2) is on.
3. Press the brush activation levers
(5).
4. Check that the safety device for
the brush lifting or the brush wear
is not active.
If the problem persists, please
contact the authorized technical
assistance.
Insufficient water on the brush
1.Check that the solenoid valve
switch (8) is on.
2. Check the level of the liquid in
the solution tank (see under
“SOLUTION TANK”).
3. Check that the solution flow
adjuster (11), placed in front
underneath the solution tank, is
sufficiently open.
4. Press the brush activation levers
(5).
If the problem persists, please
contact the authorized technical
assistance.
The machine does not clean
properly
1. The brush does not have the
suitable bristle dimension: use only
original brushes. For advice,
contact the authorized technical
assistance.
2. The solution is insufficient:
Adjust the solution flow adjuster
(11).
3. Check that the liquid detergent
is in the recommended percentage.
Contact the authorized technical
assistance for advice.
The squeegee does not dry
perfectly
1. Check that the squeegee rubbers
are clean.
2. Check that the suction hose is
correctly inserted in the proper seat
on the recovery tank.
3. Clean the suction filter.
4. Replace the squeegee rubbers if
worn.
5. Check that the suction motor
switch is on.
6. Check the level in the recovery
tank (see under “OVERFLOW
DEVICE”) and if necessary, empty
the tank.
Excessive foam production
Check that low foam detergent has
been used. Add small quantities of
anti foam liquid into the recovery
tank.
Please be aware that more foam is
produced when the floor is not
very dirty. In this case please
dilute detergent solution.
14

Tornado BD 14/4 Specifications

General

Brand	Tornado
Model	BD 14/4
Category	Scrubber
Language	English