GB GB
INTRODUCTORY COMMENT
Thank you for having chosen our
machine. This floor cleaning
machine is used for the industrial
and commercial cleaning and is
able to clean any type of floor,
except carpet cleaning. During its
forward movement, the combined
action of the brushes and the
solution removes the dirt which is
recovered through the rear suction
assembly, giving a perfectly dry
surface.
The machine must be used only for
such purpose. It gives the best
performance if it is used correctly
and maintained in perfect working
order. We therefore ask you to
read this instruction booklet
carefully whenever difficulties
arise in the course of the machine’s
use. We ask you to contact our
service department for all advice
and servicing as may prove
necessary.
GENERAL RULES OF
SECURITY
The rules below have to be
followed carefully in order to
avoid damages to the operator and
to the machine.
- Read the labels carefully on the
machine. Do not cover them for
any reason and replace them
immediately if damaged.
- The machine must be used
exclusively by authorized staff that
has been instructed for its use.
- During the operation of the
machine, pay attention to other
people and especially to the
children.
- In the presence of children guard
the machine, so that they do not
play with it.
- Do not touch or pass over the
mains cable while the brushes are
operating.
- The socket for the power supply
must be equipped with a standard
earthing (ground) system.
- Do not damage the mains cable
by squashing, bending or stressing.
- Check the integrity of the mains
cable. If during working a damage
is noticed, stop the machine
immediately and replace the cable.
- Do not mix different detergents,
avoiding harmful odors.
- Storage temperature: between
40°F and 131°F (5°C and +55°C).
- Operating temperature: between
40°F and 104°F (5°C and 40°C_.
- The humidity should not exceed
95%.
- Do not use the machine in
explosive atmosphere.
- Do not use the machine as a
means of transport.
- Do not use acid solutions which
could damage the machine and/or
the persons.
- Avoid working with the brush
when the machine is standing still,
in order to prevent floor damages.
- Do not use the machine on
surfaces covered with inflammable
liquids or dusts (for example
hydrocarbons, ashes or soot).
- In case of fire, use a powder fire-
extinguisher.
Do not use water.
- Do not strike shelvings or
scaffoldings, where there is danger
of falling objects.
- Do not use the machine on areas
having a higher gradient than the
one stated on the number plate.
- The machine has to carry out
simultaneously the operations of
washing and drying. Different
operations must be carried out in
restricted areas prohibited to non-
authorized personnel.
- Signal the areas of moist floors
with suitable signs.
- If the machine does not work
properly, check by conducting
simple maintenance procedures.
Otherwise, ask for technical advice
from an authorized assistance
centre.
- Where parts are required, ask for
ORIGINAL spare parts from the
distributor and/or from an
authorized dealer.
- Use only ORIGINAL brushes
indicated in the paragraph
“RECOMMENDED BRUSHES".
- For any cleaning and/or
maintenance operation take off the
power supply from the machine.
- Do not take off the protections
which require the use of tools to be
removed.
- Do not wash the machine with
direct water jets or with high water
pressure nor with corrosive
material.
- Every 200 working hours have a
machine check by an authorized
service department.
- Before using the machine, check
that all panels and coverings are in
their position as indicated in this
use and maintenance catalogue.
- Restore all electrical connections
after any maintenance operation.
- Provide for the scrapping of the
material of normal wear following
strictly the respective rules.
- When your machine has to stop
activity, provide for the
appropriate waste disposal of
its materials, especially oils,
batteries and electronic
components, and considering
that the machine itself has
been, where possible,
constructed using recyclable
materials.
To Next Page
Loading...
Need help?
General