GB GB
charge, causes a battery
deterioration, therby shortening the
battery life.
NOTE: Never leave batteries
completely discharged even if the
machine is not used.
During the recharging operations a
device is activated that forbids the
machine's functioning.
Bring the machine on a level
surface near to a suitable outlet.
Switch off the main switch (1).
Connect the mains cable supplied
with the machine both to the
machine and to the outlet socket as
indicated in the figure.
At the end of the charging phase
take off the mains cable.
ATTENTION:
Never charge batteries with a non-
suitable charger. Strictly follow the
instructions supplied by the
batteries and charger manufacturer.
Batteries disposal
It is mandatory to hand over
exhausted batteries, classified as
dangerous waste, to an authorized
institution according to the current
laws.
Recovery tank
Check that the cover of the suction
filter (19) is correctly secured,
after rotating the levers (18).
Furthermore, check that the
squeegee hose is correctly seated
in its seat (17).
Solution tank
The capacity of the solution tank is
indicated in the technical data.
Remove the solution tank cap (15)
placed in the top part of the
machine and fill the solution tank
with clean water at a maximum
temperature of 122°F (50°C). Add
the liquid detergent in the
percentage and conditions
recommended by the
manufacturer. To avoid excessive
foaming, which could cause
problems to the suction motor, use
the minimum percentage of
detergent. Screw down the cap to
close the tank.
ATTENTION:
Use always low foam detergent.
To avoid excessive foaming,
before starting working operation,
add into the recovery tank a
minimum quantity of anti-foam
product.
Never use pure acid.
FLOOR CLEANING
Starting the machine
The push buttons on the instrument
board are equipped with an upper
green signal light that will light
when the control is activated.
1. Switch on the machine pressing
the main switch (1).
2. Check the battery charge level
(see under “BATTERIES
RECHARGING”).
3. Lower the squeegee by rotating
the handle of the squeegee lifting
lever (5) placed in the centre of the
handle bar.
4. Press the switch for the brush
motor (2).
5. Press the switch for the suction
motor (3).
6. Press the switch for the solenoid
valve (4).
The machine is equipped with a
solenoid valve, therfore the
solution flow will be activated
automatically by pressing the
brush activation levers (7).
Releasing these levers, will stop
the flow automatically.
7. Pressing the brush activation
levers (7) the brush will start
rotating. The solution flow begins
To Next Page
Loading...
Need help?
General