Removing the Transport Wheels (continued)
G409803
3. Remove the transport wheels by pushing the
wheel-locking clips
out of the axles .
4. Carefully lower the machine off of the
kickstand by pushing forward slowly or by
lifting the lower handle support, allowing the
kickstand to spring back to the S
TORAGE
position..
Hauling the Machine
Use a trailer to transport the machine a considerable distance. Use caution while loading
and unloading the machine onto the trailer.
Note: You can use the Toro Trans Pro trailer to transport the machine. For instructions on
loading the trailer, refer to your trailer Operator’s Manual.
1. Carefully drive the machine onto the trailer.
2. Shut off the engine, engage the parking brake, and turn the fuel valve to the O
FF
position.
IMPORTANT
Do not run the engine while transporting it on a trailer because damage can occur to
the machine.
3. Use a full-width ramp for loading the machine into a trailer or truck.
4. Securely fasten the machine to the trailer.
Operation: Transporting the Machine Page 5–11 3460-887 A
To Next Page
Loading...
Need help?
General
