Toro TimeCutter 5000 User Manual

Driving Backward
Note: Always use caution when backing up and
turning.
1. Move the levers to the center , unlocked position.
2. T o go backward, slowly pull the motion-control
levers rearward ( Figure 24 ).
g008953
Figure 24
Using the Smart Speed
T M
Control System
The Smart Speed
T M
Control-System lever , located
below the operating position ( Figure 25 ), gives the
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow , and mow .
g293338
Figure 25
1. Smart-speed lever
T o change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P ARK position.
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested
uses:
T rim T ow Mow
Parking X
Heavy , wet
grass
X
T raining X
T rimming
grass
X
Bagging X
Mulching X
T owing
attachments
X
Normal
mowing
X
Moving the
machine
X
T rim
This is the lowest speed. The suggested uses for this
speed are as follows:
• Parking
• Heavy , wet grass mowing conditions
• T raining
• T rimming grass
T ow
This is the medium speed. The suggested uses for
this speed are as follows:
• Bagging
• Mulching
• T owing attachments
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
• Normal mowing
• Moving the machine
23

Toro TimeCutter 5000 Specifications

General

Brand	Toro
Model	TimeCutter 5000
Category	Lawn Mower
Language	English