20
Operating Manual Cruise 2.0 R / 4.0 R
The cable set comes complete with a CF8 135 A fuse. In case of a short circuit, the fuse
cuts the circuit and prevents any further damage.
After installing the batteries, please use the remote throttle control to transfer information
about the battery bank to the motor’s on-board computer (Section 9.2, Setup mode). Only
in this way is it possible to determine the loading status and ranges.
• Serialandparallelconguredbatteriesmustalwayshavethesame
charge condition. That is why you must use only the same type of bat-
teries in configurations (same capacity, same age, same manufacturer,
same charge condition) and fully charge each battery separately in your
charger before you connect it up. Differences in the charge condition can
lead to extremely high compensatory currents or overloads on the cables
and plugs or the battery itself. In extreme cases this could even cause fire
or injury.
• Thecablecross-sectionforbatterycongurationsmustbe25mm
2
/
American Wire Gauge 4. Make sure the battery poles are clean and
corrosion-free
• Toxthemtothebatterypoles,tightenthescrewsontheterminals
securely.
8.7 Connecting the Cruise R to Torqeedo Power 26-77 lithium-manganese
batteries
TheCruise2.0Roperateswithapowersupplyofbetween20Vand30V(relatingto
the nominal voltage). This means it can also be operated with a Torqeedo Power 26-77
lithium-manganese (LIMA) based battery.
TheCruise4.0Roperateswithapowersupplyofbetween42Vand58V(relatingtothe
nominal voltage). This means it can also be operated with two Torqeedo Power 26-77
lithium-manganese (LIMA) based batteries.
To increase the capacity, you can configure up to four Torqeedo Power batteries parallel
to each other.
To connect the Cruise 2.0 R / 4.0 R to one or two Torqeedo Power 26-77 batteries you also
need an adapter cable set / Power battery (available as an accessory).
To Next Page
Loading...
Need help?
General
