3 Tests and Diagnostics 3.32 SETUP
(b) Create State
This option sets the RAID configuration level.
NOTE: Be careful that all data of the hard disk is deleted when setting of the RAID
configuration is changed in the BIOS setup.
Therefore, recommend that the user password or the supervisor password is
registered to prevent the setting of the RAID configuration is not changed by the
third party.
Moreover, registering the supervisor password can make the user who doesn't
have the management authority prevent changing the setting of the BIOS setup.
Built in HDD Sets RAID configuration level of the built in HDD.
Second HDD Sets RAID configuration level of the second HDD.
(c) Execute Creation
This option is displayed, only when the setting is changed in the “Create
State”.
Set the cursor bar to “Execute Creation” and press Space or Back Space.
The following message will appear:
Warning: If you change RAID array, you need to install
OSagain. Are you sure? All data on the HDD(s) will be
destroyed. Do you really want to do this? If “Yes”,
please type the key string which is written in manual.
Input 1234 (press 1, 2, 3, 4 key) and press Enter.
The change of the RAID configuration will be reflected.
QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 3-117
To Next Page
Loading...
Need help?
General