4.19 TV tuner module 4 Replacement Procedures
4.19 TV tuner module
Removing the TV tuner module
The following describes the procedure for removing the TV tuner module (See Figure 4-30).
1. Disconnect the TV antenna harness from the connector PJ601 on the TV tuner
module.
2. Disconnect the TV tuner harness from the connector PJ621 on the TV tuner module
and CN5661 on the system board.
3. Remove the following screws securing the TV tuner module.
 M2.0x4.0C BIND screw x2
4. Open the left and right latches and remove the TV tuner module from the connector
CN 2220 of mini PCI slot.
M2.0x4.0C BIND
CN2220
TV antenna harness
CN5661
TV tuner harness
PJ621
PJ601
Figure 4-30 Removing the TV tuner module
4-50 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)
To Next Page
Loading...
Need help?
General