4 Replacement Procedures 4.15 Sound board
Installing the sound board
The following describes the procedure for installing the sound board (See Figure 4-25).
1. Install the sound board and secure it with the following screws.
 M2.5x3.0S FLAT BIND screw x3
2. Connect the Power SW harness to the connector CN9521 on the SD board.
3. Connect the Sound harness to the connector CN9510 on the SD board.
QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 4-43
To Next Page
Loading...
Need help?
General