E6581090
F-10
6
6.5 Operation frequency
6.5.1 Starting frequency
H
: Starting frequency setting (Hz)
• Function
The frequency set with the H parameter is put out immediately after the completion of
frequency setting.
[Parameter setting]
Title FunctionAdjustment range Default setting
H Starting frequency setting (Hz)
0.5～10.0(Hz)
0.5
Starting frequency setting
H
Output frequency [Hz]
Time [sec]
0
6.5.2 Start/stop control by means of frequency setting signals
H
: Operation starting frequency (Hz)
H
: Operation starting frequency hysteresis (Hz)
• Function
The start/stop of operation can be controlled, by simply using frequency setting signals.
[Parameter setting]
Title Function Adjustment range Default setting
H
Operation starting frequency
(Hz)
0.0～HJ (Hz) 0.0
H
Operation starting frequency
hysteresis (Hz)
0.0～HJ (Hz) 0.0
0 A B 100% Frequency command value
H
＋ H
H
H － H
HJ
The inverter starts to accelerate when the
frequency setting signal reaches point B.
Deceleration starts when t he frequency
setting signal falls belo w point A.
Output frequency [Hz]
To Next Page
Loading...
Need help?
General