Toshiba Vm Series User Manual

Chapter 2 Installation and Wiring
6F8C1637
10
2.2 Connecting the TC-net 100 Cable
Connect the TC-net 100 cable (optical fiber code) to the TNB.
WARNING
Do not touch the interior of the product except the
switches.
It may cause an electric shock.
Prohibited
CAUTION
Do not touch the cables carelessly.
A
pplying stress to the cables may cause malfunction or
accidents.
Prohibited
CAUTION
Perform a notification check in the application level
using the transmission protocol.
When an error occurs such as unable to turn on the
power, stop using and contact one of Toshiba's service
representatives.
If you have any question, consult with one of Toshiba's
service representatives.
Mandatory
Connecting the optical fiber cable
Connect the optical fiber cable to the MT-RJ optical connectors (TN-A and TN-
B) as shown below.
1 Remove the dust cover of the optical connector.
Remove the dust cover of the optical connector. Pinch the dust cover with
your fingers until it clicks, and then remove it.
2 Connect the optical fiber cable.
Insert the optical fiber cable into the MT-RJ optical connector, and press it in
until it clicks.
3 Secure the cable.
Secure the cable by clamping it so that no stress is exerted on the cable.

Toshiba Vm Series Specifications

General

Brand	Toshiba
Model	Vm Series
Category	Controller
Language	English