What to Do?
Removal of Operation Guide
44 45
How to remove the operation guide
To remove, follow the procedure below.
1
Remove the cover on the left side of the main unit, and fl ip the power
switch to "OFF".
(Page 13)
2
Remove the remote control from the hanger.
(Page 12)
3
Remove the hanger and
operation guide
.
Hanger Operation guide
Phillips screwdriver
Screw
4
Screw the hanger on the wall.
5
Mount the remote control in the hanger.
6
Flip the power switch to ON.
(Page 13)
•
The "Power" LED lights up.
7
Reinstall the cover.
(Page 25)
■
To install back the operation guide, follow the procedure above.
(Install the operation guide at step
4
.)
Troubleshooting
First, try the actions described on pages 45 - 49.
If the problem persists, consult the installer, seller, or
TOTO customer service (see contact information on the
back cover).
CAUTION
If a water leak occurs, close the shutoff
valve.
Please check fi rst
Is the Power LED lit?
■
Is the breaker on the distribution board turned on?
➞
Check whether there is a power outage or the breaker has turned "OFF".
■
Is the power switch fl ipped to "OFF"?
➞
Flip it to "ON". (Page 13 Step 2-
2)
■
Is the "Power ON/OFF" setting "OFF"?
➞
Switch it to "ON" with the remote control. (Page 13 Step 2-
2)
Is the Energy saver
LED lit?
■
While the LED is lit, energy saver
(Page 20) is in operation,
so the toilet seat temperature may be reduced or the
heater may be turned off.
Is the remote
control working?
■
Is the "
" LED on the
backside of the remote
controller fl ashing?
➞
Replace the batteries. (Pages 12, 40)
The remote control
uses
batteries
to operate.
■
Is the remote control transmitter or the remote control
receiver blocked?
➞
Remove obstructions, dirt, water droplets or any other blockages.
Remote control
transmitter
Remote control
receiver
Reference
To Next Page
Loading...
Need help?
General
