12 13
1. Insert the battery
1
Remove the
remote control
from the
hanger.
Remote
control
Hanger
2
Open the battery cover and
insert two AA batteries.
Battery cover
Close
Open
When batteries are properly loaded, all
the LEDs on the remote controll light up
for about 2 sec.
3
Mount the remote control in the
hanger.
■
About the batteries
Use dry cell, alkaline batteries.
Be sure to follow "Safety Precautions" to
prevent the batteries from rupturing or leaking
fl uid. (Pages 6, 8)
If the remote control is secured
(for anti theft)
1
Remove the screw from the
remote control fi xture.
Remove
Remote control
Hanger
Screw
Wall
Phillips screwdriver
(View from side)
2
Remove the remote control
from the hanger.
■
To secure the remote control again
Tighten and fi x the screw.
(Overtightening may cause damage to parts
such as the hanger.)
2. Turn on the power 3. Open the shutoff valve
1
Fully open the shutoff valve.
Shutoff
valve
1
Switch the breaker on the
distribution board to ON.
The wand extends and then retracts.
2
Check that the "Power" LED
lights up.
<Power>
<If the light is off>
(1) Remove the cover on the left side of the main unit,
and fl ip the power switch to ON.
Cover
Power switch
(2) Reinstall the cover. (Page 25)
<If the light is off but, the power switch is "ON">
Switch "Power" to "ON" using the remote control.
To operate from the back of remote control
Press "Power ON/OFF" button about 3 seconds
or longer.
To operate from the front of remote control
Recommended if the remote control is secured to
prevent theft, etc.
Press "Oscillating cleansing" button about
10 seconds or longer.
To turn the power "OFF"
Remove the cover on the left side of the main unit,
and fl ip the power switch to "OFF".
The "Power" LED goes off.
Cover
Power switch
Preparation
Using the Product for the First Time
Introduction
To Next Page
Loading...
Need help?
General
