Position the fabric and lower the presser
foot lever.
Step on the foot controller to begin sewing.
Turn the handwheel towards yourself to raise the needle.
Turn the pattern selection dial to choose the pattern.
Set the stitch length dial between “1” and “4”.
End of sewing
z
After sewing, turn handwheel towards
yourself until the needle is in the highest
position.
Raise the presser foot and pull out the fabric
to the rear.
Caution
Do not pull the fabric excessively while sewing.
Doing so could break the needle and cause an injury.
(For details on changing the presser foot,
refer to “Changing the presser foot” on page 26.)
Zigzag sewing foot
(Originally attached to
the sewing machine)
1~4
To Next Page
Loading...
Need help?
General
