At the tacking or the crease
that was ironed, fold back the
fabric so that wrong side faces
upward.
Sew overcasting along the edge of the fabric, and then fold the fabric as shown.
Tack or iron a crease 6 to 8 mm from the edge of the fabric. *
Blind hem stitching
In this sewing method the stitch cannot be seen on the front of the fabric.
(For details on changing the presser foot, refer to “Changing the presser
foot” on page 26.)
Wrong
side
Wrong
side
Right
side
Right
side
Fold
(tacking or crease)
Wrong side
Caution
Before changing the presser foot, use the main power switch to turn
off the sewing machine.
Not doing so could cause an injury.
Turn the handwheel towards yourself
until the needle is on the left side.
Needle on the left side
Zigzag sewing foot
Blind stitch foot
The blind stitch foot *
is only included with
model XXX34.
1~2
Overcasting
Change to the zigzag sewing foot or the blind stitch foot.
Set the stitch length dial between “1” and “2”.
Tacking or crease
Overcasting
6 - 8 mm
To Next Page
Loading...
Need help?
General
