17
Tips:
• If your Internet connection type is BigPond Cable, please go to Advanced > Network > Internet to set
your router.
• If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required
on the page, please go to Advanced > Network > Internet to complete the configuration.
• If you still cannot access the Internet, refer to the FAQ for further instructions.
4. 3. Set Up an IPv6 Internet Connection
Your ISP provides information about one of the following IPv6 Internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > IPv6.
3. Enable IPv6 and select the Internet connection type provided by your ISP.
Tips:
If you do not know what your Internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 ) Static IP: Fill in blanks and click Save.
2 ) Dynamic IP(SLAAC/DHCPv6): Click Advanced to input further information if
your ISP requires. Click Save and then click Renew.
To Next Page
Loading...
Need help?
General
