Trane Pivot BAYSTAT814 Series User Manual

BAS-SVX078E-EN
11
Note: Ensure all wires extend through the hole in the sub-base as shown below.
Wiring
1. Adjust the length and position of each wire so they reach the proper terminal on the connector block
of the sub-base.
2. Strip away 0.25 inch of insulation from each wire. Do not allow adjacent wires to short together when
connected.
3. Match and connect the unit wires to the proper terminals on the connector block.
4. Push excess wire back into the wall and seal the drilled hole to prevent air leaks.
5. Attach the unit to the sub-base.
6. Turn on power to the cooling/heating equipment.
Installation and Wiring

Trane Pivot BAYSTAT814 Series Specifications

General

Brand	Trane
Model	Pivot BAYSTAT814 Series
Category	Thermostat
Language	English