Figure 10. Back of display with ethernet and power connector
BAS-SVN040B-EN 17
Installation
Step 8: System Startup
Important: Ensure all equipment and Air-Fi® Wireless are powered and operating before
proceeding. This is because the network will be formed on power up of Tracer
Concierge Controller.
1. Apply power to the panel. Close the supply power disconnect switch that was locked open when
connecting the
120 VAC Powe
r Wires.
2. Press the power button on the Concierge Controller. Watc
h the controller go through its LED
sequence ending with dancing dashes.
Note: The network automatically stays open 1 hour. After each Air-Fi® Wireless module joins, the
1 hour timer starts over.
If time expires, press the OPEN NET button on the Air-Fi® Wireless
module to re-open the network.
Figure 11. Power button
Note: For more details or troubleshooting information, see the
• Tracer Concierge Installation, Operation, and Maintenance Guide (BAS-SVX074).
• Wireless Comm
Installation, Operation, and Maintenance (BAS-SVX40).
To Next Page
Loading...
Need help?
General
