103
Maintenance and Adjustment
dust, which may then scratch painted or
polished surfaces, if the same sponges or
cleaning cloths are used.
Where to be Careful
Avoid spraying water with any great force
near the following places:
• Instruments;
• Brake cylinders and brake calipers;
• Under the fuel tank;
• Drive chain and steering head
bearings.
Note:
• Use of soaps that are highly
alkaline will leave a residue on
painted surfaces, and may also
cause water spotting. Always use a
low alkaline soap to aid the
cleaning process.
After Washing
• Remove the rubber bands, plastic
bags and tape, and clear the air
intakes.
• Lubricate the pivots, bolts and nuts.
• Test the brakes before motorcycle
operation.
• Start the engine and run it for
5 minutes. Ensure adequate
ventilation for the exhaust fumes.
• Use a dry cloth to absorb water
residue. Do not allow water to stand
on the machine as this will lead to
corrosion.
Seat Care
To help maintain its appearance, clean the
seat using a sponge or cleaning cloth with
soap and water.
Do not spray any water at or behind the
left hand side panel. The engine’s air intake
duct is located behind the left hand side
panel and any water sprayed in this area
could enter the airbox and engine, causing
damage to both items.
Use of high-pressure spray washers is not
recommended. When using pressure
washers, water may be forced into
bearings and other components causing
premature wear from corrosion and loss of
lubrication.
Never wax or lubricate the brake discs.
Loss of braking power and an accident
could result. Clean the disc with a
proprietary brand of oil-free brake disc
cleaner.
Use of chemicals or high-pressure spray
washers is not recommended for cleaning
the seat. When using chemicals or pressure
washers the seat cover may get damaged.
To Next Page
Loading...
Need help?
General
