87
Maintenance and Adjustment
settings for rear suspension pre-load under
differing load conditions.
To change the rear suspension spring
pre-load setting, insert a suitable tool into the
hole provided in the adjuster ring.
Turn the adjuster ring clockwise to increase
spring pre-load, and counter-clockwise to
decrease spring pre-load.
Suggested Suspension Settings
Front adjuster settings refer to the number of
exposed graduation lines. There are seven
adjuster positions in total. Position one gives
the maximum amount of spring pre-load.
Rear adjuster settings are counted from one
with position one being with the adjuster
turned fully counter-clockwise. There are five
adjuster positions in total. Position one gives
the minimum amount of spring pre-load.
Bonneville T100, Bonneville 110
th
Edition, Thruxton and Scrambler
* Thruxton only
Steve McQueen™ Edition
Ensure that the adjusters are set to the
same setting on both rear suspension
units. Settings which vary from left to right
may affect handling and stability resulting
in loss of motorcycle control, and an
accident.
Ensure that the correct balance between
front and rear suspension is maintained.
Suspension imbalance could significantly
change handling characteristics leading to
loss of control and an accident. Refer to the
chart for further information or consult
your Triumph dealer.
Loading
Condition
Front
Adjuster
Position*
Rear
Adjuster
Position
Solo Riding -
Softer
61
Solo Riding -
Standard
42
Solo Riding -
Firmer
23
Rider and
Passenger
25
Loading Condition Rear Adjuster
Position
Solo Riding - Softer
1
Solo Riding - Standard
2
Solo Riding - Firmer
3
To Next Page
Loading...
Need help?
General
