EasyManuals Logo

Troy-Bilt 34087 User Manual

Troy-Bilt 34087
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Maintenance
35
WARNING
Never store machine with fuel
in the fuel tank inside a build-
ing where fumes may reach
an open flame or spark, or
where ignition sources are
present such as hot water and
space heaters, furnaces,
clothes dryers, stoves, elec-
tric motors, etc.
LUBRICATION
Oil and grease the mower accord-
ing to the recommendations listed
in the Lubrication Chart below.
Stop engine, wait for all parts to
stop moving, and disconnect
spark plug wire before perform-
ing any lubrication procedures.
Blade spindle grease fittings are
located on spindles under mower
deck. Tip mower on rear wheels
by following instructions "Tipping
Mower For Service" in this
Section of Manual. Clean fittings
before greasing. Use a hand-type
grease gun and multi-purpose
grease.
The transmission has been fac-
tory sealed and requires no lubri-
cation. If a leak should develop,
contact the Factory or your local
authorized dealer for service infor-
mation.
OFF-SEASON STORAGE
Stop engine, wait for all parts to
stop moving, and disconnect
spark plug wire before perform-
ing any storage procedures.
Review the "Maintenance and
Storage" safety rules in the
Safety section of this Manual.
If engine will be unused for 30
days or more, prepare it for stor-
age by following the recom-
mended procedures found in the
Engine Owner's Manual.
Inspect all parts for damage,
breakage, and wear. Tighten or re-
place fasteners. Contact the
Factory or your local authorized
dealer for factory-approved re-
placement parts.
Clean the exterior of the mower
thoroughly and touch up all
chipped or scratched surfaces to
prevent rust from forming.
Lubrication Chart
LUBRICATION TYPE
Change Oil
Change Oil
(Lubrication Intervals Vary
with Operating Conditions
and Type of Oil Used)
Grease
Light Oil
Multi-purpose Grease
Grease
ITEM
Engine Crankcase
Front Wheel Bearings
Control Linkages/Pivots
Blade Spindle(s)
Transmission Output Shaft
INTERVAL
First 2 hours
25-50 hours
50 hours
25 hours
100 hours
100 hours or Annually
AMOUNT REQUIRED
See Engine Manual
Change oil more often
in extremely dirty or
dusty conditions.
1-3 Strokes*
A Few Drops
1-3 Strokes*
1-3 Strokes*
* A hand-type grease gun is recommended.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt 34087 and is the answer not in the manual?

Troy-Bilt 34087 Specifications

General IconGeneral
BrandTroy-Bilt
Model34087
CategoryLawn Mower
LanguageEnglish

Related product manuals