EasyManuals Logo
Home>Truma>Water Heater>AquaGo basic

Truma AquaGo basic User Manual

Truma AquaGo basic
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Switching ON the appliance
1. Open the access door (refer to “Opening the
access door” on page8).
2. To switch on the appliance, switch the
POWER switch (Fig. 8 – 8) to one of the two
ON” positions.
Both ON positions on the POWER
switch have the same function. Choose
your preferred position.
When the green power ON LED 1 (Fig. 8 –
LED 1) is lit, the appliance is switched on.
If the red error code LED 2 (Fig. 8 – LED 2)
is lit / flashes, there is a fault or warning.
Refer to “APPENDIX A – Error Codes” on
page37).
8
LED 1
LED 2
Power
Power
Fig. 8
AquaGo® basic
The operating mode is set automatically to
“BASIC”.
The appliance is now ready for use.
Water temperature at the outlet is approxi-
mately 120°F (49°C).
AquaGo® comfort / AquaGo® comfort plus
The appliance is now ready for using the
control panel inside your vehicle. Refer
to “Operating modes (control panel)” on
page11.
Operating modes (control panel)
AquaGo® comfort / AquaGo® comfort plus
A control panel to select the operating mode
(included with the delivery from serial number
DLE60X(X)27100000).
LED 3
Rotary switch
O
Eco
Clean
Fig. 9
With the rotary switch (Fig. 9) you can choose
between the following operating modes:
Sign Operating mode / Description
ECO
The appliance is now running in energy-
saving mode.
Water temperature at outlet is ap-
proximately 120°F (49°C).
Prevention of freezing by using
propane gas. The temperature in
the appliance is automatically kept
above 41°F (5°C) .
During operation, the yellow status
LED 3 is lit.
COMFORT
The appliance is now running in a
mode that provides rapid availability of
hot water.
Water temperature at the outlet is
approximately 120°F (49°C).
Stand-by heat.
The temperature in the appliance
is automatically kept above 102°F
(39°C).
During operation, the yellow status
LED 3 is lit.
Off Stand-by. The appliance is not running
in any operating mode.
The yellow status LED 3 is off.
To switch off the POWER and gas
supply (refer to “Switching OFF
the appliance” on page12).

Table of Contents

Other manuals for Truma AquaGo basic

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Truma AquaGo basic and is the answer not in the manual?

Truma AquaGo basic Specifications

General IconGeneral
BrandTruma
ModelAquaGo basic
CategoryWater Heater
LanguageEnglish

Related product manuals