Figure 17: Setup Mode
Changing the Display Temperature
The o
ven can display the temperature in either
Celsius or F
ahrenheit units. To change the display
temperature, press L1 in SETUP MODE (Figure 17).
E
dit M
odes Select Screen
The edit modes select screen (Figure 19) allows the
user to switch between full edit, rigid, and flex for
profile name, belt speed, temperature, and % air.
For more information on the different edit options,
see E
diting a Cooking Profile
on page 11.
T
o access the edit modes select scr
een,
1.
P
r
ess L3 (Figure 17) to access the password
scr
een (F
igur
e 18).
2.
I
nput the password
6 6 3 3 by pressing the
soft keys adjacent to the numbers.
T
o change the edit option (F
igure 19),
-
P
ress L1 to select full edit or rigid for the profile
name.
-
P
r
ess L3 to select full edit, rigid, or flex for the
belt speed.
-
P
r
ess R1 to select full edit, rigid, or flex for the
profile cook temperature setting.
- Press R3 to select full edit, rigid, or flex for the
% air setting.
Changing the Display Language
NO
TE: Feature is not available on all oven models.
From the setup menu screen (Figure 17), press R1
to set the language to E
nglish, French, German, or
S
panish.
Info Screen
The info scr
een (Figure 20) is used to display the
follo
wing information in an easy to access place:
- Serial number
- Electrical compartment temperature
- Voltage
-
Total time the oven has been on
-
Total time the oven has been idle
- F
irmware version
T
o access the info screen, press R3 within the SETUP
MODE
(Figure 17).
Upda
ting the F
irmware
F
rom the oven off screen,
1.
I
nser
t the gray smart card (see Figure 14, page
15) with the gold chip facing the fr
ont of the
oven. If multiple smart cards are required, they
will be labeled in sequence - ensure the correct
sequence is followed.
2.
F
r
om the
COOLING DOWN or OVEN OFF MODE,
press and hold the idle key until the oven resets
(approximately 5 seconds). The display will go
blank until the upload is complete.
3. When the oven beeps one long high tone, the
load was successful. If a second card was
provided, insert it.
4.
When the oven restarts and the display turns
on, the update is complete. R
emove the smart
card from the oven.
To Next Page
Loading...
Need help?
General