20
Initiating a Burn-In Test
NOTE: Burn-in tests are for manufacturing use
only
. DO
NOT initiate a burn-in test unless
expressly instructed by TurboChef.
T
o initiate a burn-in test, Press L2 (Figure 22,
page 17) on scr
een 2 of the TEST MODE.
The burn-in test (Figure 28) runs the oven for 45
minutes to ensure correct oven operation. When
the burn-in test completes, the burn-in complete
scr
een (F
igure 29) will appear. Press any key to
send the o
v
en to the COOLING DOWN MODE. If
the burn-in test fails, the applicable err
or code
will appear and the o
v
en will return to the COOL-
ING
DO
WN
or
OVEN OFF MODE.
Erasing Oven Settings
To erase oven settings, press L3 (Figure 22, page
17) on screen 2 of the TEST MODE to access the
erase screen (Figure 30). From the erase screen,
- Press L1 to erase all menu, belt, and
configuration settings.
-
P
ress L2 to clear the fault counters.
-
P
ress L3 to clear the operational hours.
The o
v
en will ask y
ou to confirm the action
(F
igur
e 31 sho
ws the confirm clear faults scr
een);
pr
ess R3 to confirm or the back/off key to cancel.
CA
UTION: Settings, fault counts, and hours
cannot be retrieved once the erase option is
confirmed.
Viewing the Serial Number
The serial number is located at the bottom of
screen 2 of the TEST MODE (Figure 22, page 17).
CA
UTION:
Write this number down
befor
e r
eplacing the I/O control board.
Replacing the I/O control board will erase
this number from the oven’s memory.
I
f replacing a control board, see page 19 for re-
entering the serial number
.
OVEN MODES
To Next Page
Loading...
Need help?
General