Ubiquiti UCK-G2-PLUS User Manual

38
HDD Replacement
The Cloud Key Gen2 Plus comes pre-installed with a 1TB SATA HDD.
If you want to replace it, you must use a 2.5” SATA HDD and follow
these instructions:
1. Back up your data from the drive.
2. Power off the Cloud Key Gen 2 Plus to prevent any
software disruption.
3. On the bottom of the Cloud Key Gen 2 Plus, slide the HDD
Latch to release the HDD tray.
WARNING: Do not release or operate the HDD Latch
while the Cloud Key Gen2 Plus is in use or powered on.
4. Gently flex the sides of the tray to release the drive and
remove the drive from the tray.

Ubiquiti UCK-G2-PLUS Specifications

General

PoE Input	802.3af PoE
Management	UniFi Network Application
Product Name	Ubiquiti UniFi Cloud Key Gen2 Plus
Category	Network Controller
Ethernet Ports	1 x 10/100/1000 Mbps
USB Ports	1 x USB-C
Display	LCD Touchscreen
Operating Temperature	0 to 35° C (32 to 95° F)
Supported Devices	UniFi devices
Memory	3 GB
Storage	1 TB HDD (upgradeable)