UTD2000 Series User Manual
62
Chapter XV Appendix
Appendix A Accessories
A string of power cord complying with country standard.
A string of USB cable (UT-D14)
A pair of passive probe (50MHz) /(150MHz) /(200MHz)
Multimeter module (UT-M12)
Appendix B Maintenance and Cleaning
(1) General Maintenance
Please do not store or place the instrument at any places where the LCD of the
instrument is exposed to sunlight directly.
Caution: Please do not stain the instrument or probe with spray, liquid or solvent, so
as to avoid damaging the instrument or probe.
(2) Clearing
Check the instrument and probe frequently. Clean the surface of the instrument
according to the following steps:
① Please wipe the surface of the instrument and probe with soft cloth. Pay attention
not to scratch the LCD screen.
② Wipe the instrument with wet cloth after disconnecting the power supply. Use
detergent or clear water to clean. Do not use any abrasive chemical cleaning agent so as
to avoid damaging the instrument or probe.
Warnings: Please make sure that the instrument is completely dry before powering on again, to avoid
electrical short circuit or injury.
Appendix C Warranty
UNI-T (Uni-Trend Technology (China) Co., Ltd.) warrants that product produced and
marketed by it will be free from defects in materials and workmanship for a period of three
years from the date of shipment by the authorized dealer. If any such product proves
defective during this warranty period, UNI-T will repair the defective product or provide a
replacement according to specific terms and conditions of the warranty. To request
maintenance and repair service or a full copy of the warranty, please contact your nearest
UNI-T sales and maintenance office.
Save and except the guarantee given herein or in other applicable warranty, UNI-T
makes no other express or implied guarantee, including but not limited to any implied
To Next Page
Loading...
Need help?
General
