UTG1000A Series 13
2. Heat Dissipation Holes
To ensure this instrument dissipate heat well, please do not block these holes.
3. Insurance Pipe
When AC input current is more than 2A, the fuse will cut off the AC input to protect the device.
4. Main Power Switch
Press down on “I” to power the instrument, and press down on “O” to cut off AC input.
5. AC Power Input Terminal
This device supports AC power from 100V to 240V, 45Hz to 440 Hz, and power fused is 250V, T2 A.
2.2.3 Function Interface
Function interface is shown in figure 2-3:
Figure 2-3
Detailed Description:
Channel information: 1) “ON/OFF” on the left is channel open information. 2) There is a “Limit” logo indicates
output range limit where white is valid and grey is invalid. The matched impedance of output terminal (1Ω to
1KΩ adjustable, or high resistance, factory default is 50Ω). 3) The right side is the current valid waveform.
Softkey labels: Softkey labels are used for identifying menu softkey functions and menu operation softkey
functions.
1) Labels on the right of screen: Highlighted display indicates that the label is selected. If not, press
corresponding softkey to select.
Channel Information
Softkey
Waveform Parameter List
To Next Page
Loading...
Need help?
General
