Administration
A31003-C1000-M102-5-76A9, 09/2017
64 OpenScape Desk Phone CP200/CP205/CP400/CP600 HFA, Administration Manual
administration.fm
IP Network Parameters
3.3.8 SNMP
The Simple Network Management Protocol is used by network management systems for mon-
itoring network-attached devices for conditions that warrant administrative attention. An SNMP
manager surveys and, if needed, configures several SNMP elements, e.g. VoIP phones.
OpenScape Desk Phone CP phones support SNMPv1.
There are currently 4 trap categories that can be sent by the phones:
Standard SNMP traps
OpenScape Desk Phone CP phones support the following types of standard SNMP traps, as
defined in RFC 1157:
• coldStart: sent if the phone does a full restart.
• warmStart: sent if only the phone software is restarted.
• linkUp: sent when IP connectivity is restored.
QoS Related traps
These traps are designed specifically for receipt and interpretation by the QDC collection sys-
tem. The traps are common to SIP phones, HFA phones, Gateways, etc.
Traps specific to OpenScape Desk Phone CP phones
Currently, the following traps are defined:
TraceEventFatal: sent if severe trace events occur; aimed at expert users.
TraceEventError: sent if severe trace events occur; aimed at expert users.
Data required
• Trap sending enabled: Enables or disables the sending of a TRAP message to the SNMP
manager.
Value range: "Yes", "No"
Default: "No"
• Trap destination: IP address or hostname of the SNMP manager that receives traps.
• Trap destination port: Port on which the SNMP manager is receiving TRAP messages.
• Default: 162
• Trap community: SNMP community string for the SNMP manager receiving TRAP mes-
sages.
Default: "snmp"
• Queries allowed: Allows or disallows queries by the SNMP manager.
• Query password: Password for the execution of a query by the SNMP manager.
To Next Page
Loading...
Need help?
General