Unitech KP3800 User Manual

11Keyboard Manual
Terminator
The Terminator is a command that follows the input of bar code
data. Four different terminators can be selected here: “Enter”,
“Return (on numeric keypad)”, “Field Exit or Right Control”, or
“None”. Alternative terminators (such as Tab) can be be configured
via the Postamble function (see page 13).
Default is “Enter”
Double Verification
Double Verification enables the scanner to verify the accuracy of the
output by outputting only after a specified number (from 0 to 7) of
identical results. For instance, if 3 is selected, the scanner will not
output the bar code data until it’s obtained 4 identical scan results.
Because the scanner normally scans at a rate of 33 scans per
second (unless it’s a wand), this process should take less than a
second, even for higher values.
Default is “0-Off”
Scanner Port
Terminator, Use Code ID, Double Verification, Scanning Mode,
Label Type, Aim Function for Long-Range Engine, Aim Time for
Long-Range Engine, Preamble, and Postamble are the parameters
for Scanner Port configuration.
Use Code ID
The Code ID function can be used to
identify the type of bar code that is
being scanned by inserting an identify-
ing letter (refer to chart at right) at the
beginning of the bar code output.
For example, if the Code ID function is
on, and a bar code value of “54321”
was output as “M54321”, the bar code
would thus be identified as type Code
39.
Default is “No”.
UPC-A
A
UPC-E E
EAN-13 F
FFEAN-8
I 2 of 5 I
S 2 of 5
H
Code 39 M
Codabar N
Code 93 L
Code 128 K
UCC/EAN128 ]C1
MSI O
Code 32 T
Plessey Code P
Label Code IV, V B
C
China Postal Code
Code 11 / Telpen J

Unitech KP3800 Specifications

General

Brand	Unitech
Model	KP3800
Category	Keyboard
Language	English