13Keyboard Manual
Aiming Time for Long Range Engine
The Aiming Time function specifies the duration of the Aim Function
(see previous page). Length of duration can be specified from
500ms to 2 seconds, in half-second increments.
Default is “1 second”.
Scanner Port, continued
Postamble
Identical to Preamble (above), but characters
are inserted after scanned data.
Default is “None”.
A common postamble would be a “Tab” after the
bar code input (usually in lieu of an “Enter”
terminator). In this case, set the Terminator to
“None” (see page 11) and input “<t>” (less-than
sign, lower case “t”, greater-than sign) in the
“Enter Content” area of the “Define Preamble”
pop-up box. Then click “OK”.
The above special characters must be bracketed by < > symbols as
shown.
Function codes (F keys, Cursor up, Enter, etc.) can also be inserted
via hexadecimal code (accessable in a linked menu) and must
include surrounding brackets (<>).
Letters and numbers should be entered directly by keyboard input
without surrounding brackets (<>).
Default is “None”.
Preamble
Insert a string of characters prior to the actual
scanned data. Pre-defined characters include:
•
<t>: Tab
•
<r>: Carriage Return
•
<n>: Line Feed
•
<“>: “ (quotation marks)
•
<dd>: character in hexadecimal notation
<<>: < (less than)
•
•
<>>: > (greater than)
To Next Page
Loading...
Need help?
General
