3. Electric power supply
- The connection to the electrical
power supply system must be carried
out according to the current local
regulations.
- Before connecting the appliance,
make sure that the voltage and the
frequency correspond to those stated
on the data plate of the appliance.
- Place an isolation switch between the
appliance and the network in such a
way that it will be easily accessible
after the installation.
- Each unit must have its own switch.
Never connect two units to the same
switch.
- The appliance must be connected to
the electricity mains earth conductor.
- The appliance must be included in an
equipotential system whose efficiency
must be properly checked according to
the current laws. This connection must
be done between different appliances
through the terminal marked with the
appropriate equipotential symbol. The
equipotential conductor must have a
minimum section of 10 mm2.
Electric Power Supply
Isolation switch
Electrical connections
13
To Next Page
Loading...
Need help?
General